PDA

View Full Version : Question on Neurocom Equitest data



fgborg82
05-13-2004, 09:04 PM
Dear Biomechanics List readers

I am analyzing data exported (ASCI) from a Neurocom Smart Equitest device.
The data contains force values from the force transducers. The
documentation (accompanying the data) does not say what unit is used. I am
just guessing it is Newton from the typical size of the numbers - anyone
knows for sure? Secondly, in order to compute the COP-coordinates i would
need data on the physical separation of the transducers. Anyone knows
these figures? I would measure these parameters directly but the device is
situated some 450 km away ... so, if anyone can fill in these gaps i would
be grateful.

Best regards

Frank Borg





Frank Borg
(Biosignals Project)

Jyväskylä University
Chydenius Institute

PB 567
Pitkänsillankatu 1-3
FIN-67701 Kokkola
Finland

Fax: +358-6-8294202
Tel: (06) 8294 268
GSM: 040 - 8448 376


###########################################

This message has been scanned by F-Secure Anti-Virus for Microsoft
Exchange.
For more information, connect to http://www.F-Secure.com/

-----------------------------------------------------------------
To unsubscribe send SIGNOFF BIOMCH-L to LISTSERV@nic.surfnet.nl
For information and archives: http://isb.ri.ccf.org/biomch-l
Please consider posting your message to the Biomch-L Web-based
Discussion Forum: http://movement-analysis.com/biomch_l
-----------------------------------------------------------------