PDA

View Full Version : References needed regarding force and lever arm position datacapture



jcannon41
07-02-2004, 02:45 PM
Hello all,

I am in desperate need for some references... Possibly one (or more) of you may be able to point me in the right direction!

I have linked our Kin-Com isokinetic dynamometer to an external piece of equipment (similar to Labview or the like) so that force and lever arm position data can be sampled synchronously at a user defined rate up to 50kHz, rather than 200Hz at which the kin-com software samples data. I am writing a chapter for my thesis on the validity of this approach, but I am unable to locate any references that have used a similar approach (that is, sampled data generated by a commerical isokinetic device using a secondary piece of equipment).

Any assistance would be greatly appreciated.

Kind regards,

Jack Cannon


*******************************************
PhD Student
School of Human Movement Studies
Faculty of Education
Charles Sturt University
Panorama Avenue
Bathurst 2795
Australia

Ph. (02) 6338 4334
Fax. (02) 6338 4065
*******************************************

-----------------------------------------------------------------
To unsubscribe send SIGNOFF BIOMCH-L to LISTSERV@nic.surfnet.nl
For information and archives: http://isb.ri.ccf.org/biomch-l
Please consider posting your message to the Biomch-L Web-based
Discussion Forum: http://movement-analysis.com/biomch_l
-----------------------------------------------------------------