PDA

View Full Version : Cybex NORM error message



jluk49
01-25-2005, 12:32 PM
Dear Colleagues,

I would like to know if anyone have idea about the two error messages from
Cybex NORM - "Dyna Object Error" during position calibration.

When I click "OK" to conduct the position calibration, the error messages
were shown.

Error 1
CalCont Returned Error Code:99
Firmware did not acknowledge: Bad command received.

Error 2
SetldleSpeed Returned Error Code:99
Firmware did not acknowledge: Bad command received.

The computer OS system is DOS 6.22 and Windows 3.11. I did conduct the
scandisk and speedisk to defrag the hard disk before. Moreover, I have
conducted the data management from the software provided by Cybex NORM.

Any idea on the sources of problem and suggestions for improvement
(hardware or software) are welcome.

Thank you for your attention.

Best regards,

Jim



*****************************************
Lecturer
Department of Physical Education
Faculty of Social Sciences
Hong Kong Baptist University
Kowloon Tong, Hong Kong
Tel: (852) 3411 7759
Fax: (852) 3411 5757
Email: jimluk@hkbu.edu.hk
*****************************************

-----------------------------------------------------------------
To unsubscribe send SIGNOFF BIOMCH-L to LISTSERV@nic.surfnet.nl
For information and archives: http://isb.ri.ccf.org/biomch-l
-----------------------------------------------------------------