PDA

View Full Version : Load Capacity of Material Test System



Ling Ling (dr)
06-03-1998, 12:58 PM
Hi, All,

We are going to buy a Material Test System for Biomechanical Testing. We
think that 10KN Maximum Axial Load and 100Nm Maximum Torsion Load are
enough. But someone told us 10KN Load Capacity is not enough and suggested
us to buy one higher.

Any information about this problem will be very helpful.

Best regards

Ling Ling
Email: MLing@ntu.edu.sg
Tel: 7996948

-------------------------------------------------------------------
To unsubscribe send UNSUBSCRIBE BIOMCH-L to LISTSERV@nic.surfnet.nl
For information and archives: http://www.bme.ccf.org/isb/biomch-l
-------------------------------------------------------------------