PDA

View Full Version : FYI: C3D m-file



Kyu-jung Kim, Ph.d.
10-20-1998, 11:33 PM
For those of you who are using "getc3d.m" for Vicon, the MATLAB script reading c3d files. If there's continuing interest, I'll revise the script to address most problems.

KJK

-----Original Message-----
From: Dr. Chris Kirtley [SMTP:rskirt@polyu.edu.hk]
Sent: Tuesday, October 20, 1998 10:46 PM
To: Kyu-Jung Kim, Ph.D.
Subject: Re: C3D m-file

Dear Kyu-Jung,

Thanks for getting back to me. In fact I just figured out what should be done - Vicon uses DEC format, so I needed to say:
fopen(fname,'r+','d')
^^^

This is for VAX D floating point numbers. After that small adjustment everything looks fine - 3 days work for three characters!
Thanks again,

Chris
--
Dr. Chris Kirtley MD PhD
Assistant Professor
Dept. of Rehabilitation Sciences
The Hong Kong Polytehnic University
Hung Hom Hong Kong

Tel +852 2766 6755
Fax +852 2330 8656
WWW http://www.polyu.edu.hk/cga

-------------------------------------------------------------------
To unsubscribe send UNSUBSCRIBE BIOMCH-L to LISTSERV@nic.surfnet.nl
For information and archives: http://www.bme.ccf.org/isb/biomch-l
-------------------------------------------------------------------