Tweet
To whom it may concern,
We have a Cybex II in our motion analysis laboratory, and are using a
powerlab 410 from AD instruments to collect torque and angle output.
This information will be used for isometric testing. However, we
having difficulties calibrating and converting the information from
voltage into usable units (i.e. N-m or degrees).
Does anyone have information on how to use such a setup to collect
dynamometer data? Any help is greatly appreciated.
Thank you very much,
Vipul Lugade
Virginia Klausmeier
Motion Analysis Lab
University of Oregon
(541)346-1033
vlugade@gmail.com
vklausme@uoregon.edu
We have a Cybex II in our motion analysis laboratory, and are using a
powerlab 410 from AD instruments to collect torque and angle output.
This information will be used for isometric testing. However, we
having difficulties calibrating and converting the information from
voltage into usable units (i.e. N-m or degrees).
Does anyone have information on how to use such a setup to collect
dynamometer data? Any help is greatly appreciated.
Thank you very much,
Vipul Lugade
Virginia Klausmeier
Motion Analysis Lab
University of Oregon
(541)346-1033
vlugade@gmail.com
vklausme@uoregon.edu