Tweet
One can use the virtual reality freeware XVR
http://www.vrmedia.it/
julien
>
>
> -------- Original Message --------
> Subject: Re: [BIOMCH-L] Using Real-Time VICON with MATLAB
> Date: Wed, 12 Dec 2007 09:45:23 -0500
> From: Philippe Archambault, Dr.
> Reply-To: Philippe Archambault, Dr.
> To: BIOMCH-L@NIC.SURFNET.NL
>
>
>
> Ravi,
>
> I am also looking at possible solutions on how to use a motion capture
> system in real time. I see two potential pitfalls with a real time
> system combining Vicon and Matlab xPC. The first is that Vicon
> communicates its data through TCP/IP, however, xPC can only use UDP;
> TCP/IP is not possible and this has been confirmed by a Mathworks
> software engineer.
>
> The other problem is that Vicon introduces a delay of 10-50 ms
> (depending on your setup) between actual, physical movement and the time
> that this data is communicated to the target computer. For my needs,
> this delay is much too high. Personally, I believe that an active marker
> system is more appropriate for real time.
>
> Hope this helps,
>
> Philippe
>
> Philippe Archambault, OT, PhD
> Assistant professor
> School of Physical & Occupational Therapy, McGill University
> 3654 Promenade Sir-William-Osler
> Montreal QC H3G 1Y5
> T: (+1) 514 398-7323
> F: (+1) 514 398-6360
> W: www.mcgill.ca/spot
>
>
> On Dec 10, 2007 7:42 AM, Raviraj Nataraj
> wrote:
>
>> Hello, Biomech-L,
>>
>> Our lab has recently upgraded its VICON motion capture system, which
>> now includes real-time data capture. We are looking to use real-time
>> marker data for controller feedback. The controller will be under
>> real-time operation using the xPC-Target software toolkit within
>> MATLAB. Thus, we ultimately need to link the real-time data stream
>> from VICON to a "target" computer. If anyone has had experience with
>> this or something similar, any advice on how best to proceed would be
> greatly appreciated.
>>
>> Sincerely,
>> Ravi Nataraj
>> PhD Student, BME Department, Case Western Reserve University Motion
>> Study Lab, Cleveland Stokes VAMC
>>
>
> ---------------------------------------------------------------
> Information about BIOMCH-L: http://www.Biomch-L.org
> Archives: http://listserv.surfnet.nl/archives/Biomch-L.html
> ---------------------------------------------------------------
>
>
>
julien Lagarde PhD
http://julienlagarde.free.fr
lagarde@ccs.fau.edu
@ Movement Science Dept
Faculté des Sciences du Sport tel: (33) 4 67 41 57 35
cell: 06 77 46 78 39
700, Av. du Pic St Loup
34090 Montpellier, France
http://www.edm.univ-montp1.fr/
http://www.enactivenetwork.org
http://www.skills-ip.eu
@ Human Brain Behav Lab, Boca Raton fl usa,
Center for complex systems brain sciences
http://www.ccs.fau.edu/section_links/HBBLv2/
julien Lagarde PhD
http://julienlagarde.free.fr
lagarde@ccs.fau.edu
@ Movement Science Dept
Faculté des Sciences du Sport tel: (33) 4 67 41 57 35
cell: 06 77 46 78 39
700, Av. du Pic St Loup
34090 Montpellier, France
http://www.edm.univ-montp1.fr/
http://www.enactivenetwork.org
http://www.skills-ip.eu
@ Human Brain Behav Lab, Boca Raton fl usa,
Center for complex systems brain sciences
http://www.ccs.fau.edu/section_links/HBBLv2/
http://www.vrmedia.it/
julien
>
>
> -------- Original Message --------
> Subject: Re: [BIOMCH-L] Using Real-Time VICON with MATLAB
> Date: Wed, 12 Dec 2007 09:45:23 -0500
> From: Philippe Archambault, Dr.
> Reply-To: Philippe Archambault, Dr.
> To: BIOMCH-L@NIC.SURFNET.NL
>
>
>
> Ravi,
>
> I am also looking at possible solutions on how to use a motion capture
> system in real time. I see two potential pitfalls with a real time
> system combining Vicon and Matlab xPC. The first is that Vicon
> communicates its data through TCP/IP, however, xPC can only use UDP;
> TCP/IP is not possible and this has been confirmed by a Mathworks
> software engineer.
>
> The other problem is that Vicon introduces a delay of 10-50 ms
> (depending on your setup) between actual, physical movement and the time
> that this data is communicated to the target computer. For my needs,
> this delay is much too high. Personally, I believe that an active marker
> system is more appropriate for real time.
>
> Hope this helps,
>
> Philippe
>
> Philippe Archambault, OT, PhD
> Assistant professor
> School of Physical & Occupational Therapy, McGill University
> 3654 Promenade Sir-William-Osler
> Montreal QC H3G 1Y5
> T: (+1) 514 398-7323
> F: (+1) 514 398-6360
> W: www.mcgill.ca/spot
>
>
> On Dec 10, 2007 7:42 AM, Raviraj Nataraj
> wrote:
>
>> Hello, Biomech-L,
>>
>> Our lab has recently upgraded its VICON motion capture system, which
>> now includes real-time data capture. We are looking to use real-time
>> marker data for controller feedback. The controller will be under
>> real-time operation using the xPC-Target software toolkit within
>> MATLAB. Thus, we ultimately need to link the real-time data stream
>> from VICON to a "target" computer. If anyone has had experience with
>> this or something similar, any advice on how best to proceed would be
> greatly appreciated.
>>
>> Sincerely,
>> Ravi Nataraj
>> PhD Student, BME Department, Case Western Reserve University Motion
>> Study Lab, Cleveland Stokes VAMC
>>
>
> ---------------------------------------------------------------
> Information about BIOMCH-L: http://www.Biomch-L.org
> Archives: http://listserv.surfnet.nl/archives/Biomch-L.html
> ---------------------------------------------------------------
>
>
>
julien Lagarde PhD
http://julienlagarde.free.fr
lagarde@ccs.fau.edu
@ Movement Science Dept
Faculté des Sciences du Sport tel: (33) 4 67 41 57 35
cell: 06 77 46 78 39
700, Av. du Pic St Loup
34090 Montpellier, France
http://www.edm.univ-montp1.fr/
http://www.enactivenetwork.org
http://www.skills-ip.eu
@ Human Brain Behav Lab, Boca Raton fl usa,
Center for complex systems brain sciences
http://www.ccs.fau.edu/section_links/HBBLv2/
julien Lagarde PhD
http://julienlagarde.free.fr
lagarde@ccs.fau.edu
@ Movement Science Dept
Faculté des Sciences du Sport tel: (33) 4 67 41 57 35
cell: 06 77 46 78 39
700, Av. du Pic St Loup
34090 Montpellier, France
http://www.edm.univ-montp1.fr/
http://www.enactivenetwork.org
http://www.skills-ip.eu
@ Human Brain Behav Lab, Boca Raton fl usa,
Center for complex systems brain sciences
http://www.ccs.fau.edu/section_links/HBBLv2/