Announcement

Collapse
No announcement yet.

Re: Construction of Electrogoniometer

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Re: Construction of Electrogoniometer

    Does anyone out there have information on how to construct an
    electrogoniometer (ie, what specifications are required in a
    potentiometer,etc), or whether one can be purchased commercially (and if
    so, any addresses would be helpful).

    I am trying to construct (or procure) an electrogoniometer to obtain hip,
    knee and ankle angles in conjunction with EMG data while cycling on an
    ergometer. We have a Noraxon tethered EMG system. I assume I would need
    a power supply, some connector to get the EMG signal from the control
    unit and from the elgon to the A/D board.

    Unfortunately, more often than not, we have to be our own technicians as
    well. I have not had a whole lot of experience doing this and any
    information or help will be greatly appreciated.

    If there is a large enough response or interest to my inquiry, I will
    post it on the network.

    ************************************************** ********************
    * *
    * Danny Too Phone: (702)-895-4875 *
    * University of Nevada Las Vegas Fax: (702)-895-4231 *
    * 4505 Maryland Parkway E-mail: tood@nevada.edu *
    * Las Vegas, NV 89154-3034 *
    * *
    ************************************************** ********************
Working...
X