Announcement

Collapse
No announcement yet.

Vicon and Datapac 2K2

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Vicon and Datapac 2K2

    Hi All,

    We have been collecting data and running models through Vicon Nexus. We have been doing some signal processing/anlaysis by creating a c3d file in Nexus, and then opening that file in Datapac 2K2. Recently, for some inexplicable reason, Datapac is not reading c3d files on recently collected data (data from this time last year is still read without difficulty). We've contacted Vicon, and they have stated that there has been no change to the way they write c3d files. Run Technologies went out of business, so we can't contact them. We appear to be stuck.

    Has anyone had similar difficulties? And if so, have you found a solution?

    It appears as though we may need to find a new software solution to perform signal processing on a c3d file. Does anyone have any recommendations? We work with students who are primarily undergrad/inexperienced grad students.

    Thanks in advance. As always, I will post a summary of replies.

    Sean

    Sean P. Flanagan, PhD, ATC, CSCS
    Associate Professor
    Department of Kinesiology
    California State University, Northridge
    18111Nordhoff Street
    Northridge, CA 91330-8287
    phone: 818.677.7507
    fax: 818.677.3207
    web: www.csun.edu/~sflanagan
Working...
X