Announcement

Collapse
No announcement yet.

open sim inverse dynamics external loads

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Jennifer Hicks
    replied
    Re: open sim inverse dynamics external loads

    For those following this question, a discussion chain has been started on the OpenSim user forum:

    https://simtk.org/forums/viewtopic.p...be5c079fd8f227

    Best wishes,
    Jen Hicks
    OpenSim R&D Manager

    Leave a comment:


  • Manvendra Singh
    replied
    Re: open sim inverse dynamics external loads

    For validating your model, you need to do inverse dynamics analysis and that will need external forces. For spine only model, I guess there is no way to apply and measure external forces. You will need some end effector parts to be added into your model, like pelvis and hips, so that you could measure forces and moments, by some method, like an instrumented chair, for simple tasks like turning, bending, to compute forces and torques being generated at individual spinal joints. The model could be validated through Forward dynamics analysis on your model, applying computed forces and torques in Inverse Dynamics analysis at individual joints, and comparing resulting motions and external forces with mesured quantities.

    Leave a comment:


  • Joy Ku
    replied
    Re: open sim inverse dynamics external loads

    Hi Brandon,

    You may also want to post your question to the OpenSim discussion forum located here: https://simtk.org/forums/viewforum.php?f=91.

    Joy
    Director, Simbios
    Director of Dissemination and Training, NCSRR

    Leave a comment:


  • Brandon Bucklen
    started a topic open sim inverse dynamics external loads

    open sim inverse dynamics external loads

    Hi,

    My group and I are working on a musculoskeletal model of the spine in opensim. We are all fairly beginner here and have been running through the tutorials, looking at the confluence web-site etc.

    We have a generalized model developed from the literature, and as a result we do not have external load data, such as force plates, etc.

    In fact the model does not go to the feet, but stops at the pelvis.

    We are attempting to solve an inverse dynamics problem and determing the internal loads/torques at the joints of the spine. We are able to do so, but have left "unchecked" the external load tab, because we do not have external loads.

    Is our output of internal forces/torques just junk because we do not have applied forces? Without applied forces how is it even able to solve at all? The only thing I can think of, is that gravity is incorporated through the center of mass and is the applied force.

    Any help is appreciated.

    Thanks
Working...
X