Dear Friends,
Has anyone successfully interfaced a Bertec USB device (e.g. the 5050 portable balance plate) with LabView? I have been trying using the Bertec .NET SDK, but have not been successful so far. If anyone is willing to share a minimal VI or talk offline about any tricks you had to employ to get it to work, I'd really appreciate it! My main problem right now appears to be the use of pointers (Bertec SDK uses them, LabView doesn't).
Thanks,
Ajit Chaudhari, PhD, FACSM
Ohio State University
Columbus, OH, USA
chaudhari.2@osu.edu
Has anyone successfully interfaced a Bertec USB device (e.g. the 5050 portable balance plate) with LabView? I have been trying using the Bertec .NET SDK, but have not been successful so far. If anyone is willing to share a minimal VI or talk offline about any tricks you had to employ to get it to work, I'd really appreciate it! My main problem right now appears to be the use of pointers (Bertec SDK uses them, LabView doesn't).
Thanks,
Ajit Chaudhari, PhD, FACSM
Ohio State University
Columbus, OH, USA
chaudhari.2@osu.edu