Collecting Nexus data at specified increments

[Devjani Saha]

I would like to collect Vicon Nexus data at specific time increments for a specific period of time (i.e. collect data every 30 seconds for 2 second
intervals). Has anyone been able to do this within Vicon Nexus, version 1.8.4? Please let me know if you have any suggestions. Thanks.

[Joey Webb]

Re: Collecting Nexus data at specified increments

Have you contacted Vicon? They would be the best to advise you.

[Tim Wrigley]

Re: Collecting Nexus data at specified increments

The GPIO interface that is part of the MX hardware provides the ability to automate starting and stopping capture. A signal generator programmed to generate square wave pulses with the desired on/off duty cycle would achieve what you want. We've used the GPIO interface to wire a remote control switch box to control capture. Check the MX hardware reference manual.

Tim Wrigley
University of Melbourne