Tweet
Does anyone have any experience with attempting to do remote control on either a Biodex RTM 500 (Model 945) or a Biodex Gait Trainer 3 Treadmill?
Both treadmills have an 8-pin ethernet port (see attached images) but I cannot find anything in the device manual regarding remote control of the device through this port. Therefore, I wanted to reach out to our community here and see if anyone has tried this previously and if you all have any advice on how to get started.
There is a different model Biodex treadmill, an RTM 400 model, which I found the manual for online which discusses having an RS-232 or RS-422 serial port for remote control of the device, but I cannot find the same information for the two models I'm inquiring about here.
Thank you for taking the time to read this, any input you may have is greatly appreciated.
Cheers,
Dan
Both treadmills have an 8-pin ethernet port (see attached images) but I cannot find anything in the device manual regarding remote control of the device through this port. Therefore, I wanted to reach out to our community here and see if anyone has tried this previously and if you all have any advice on how to get started.
There is a different model Biodex treadmill, an RTM 400 model, which I found the manual for online which discusses having an RS-232 or RS-422 serial port for remote control of the device, but I cannot find the same information for the two models I'm inquiring about here.
Thank you for taking the time to read this, any input you may have is greatly appreciated.
Cheers,
Dan